There are two kinds of problems of artificial lawn edge warping, one is in the construction of the edge warping, and is in the use of the process of the edge warping. The former is better to solve, because the construction has not been completed, the latter is more troublesome, because it has been completed, in the use of the process of rework is very troublesome.
The reason is that the construction of artificial lawn is relatively simple because it can be redone at any time. This time there are two reasons for warping edges, one is less glue, sticky and unstable caused by warping edges, the other is in the glue after drying for too long caused by warping edges. This should pay attention to smear glue to be moderate, not too large, of course, not too little, too much drying time lengthened, and in very rare cases will also cause warping. After the glue is applied, it can be dried for about five to ten minutes, or the small piece can be used to test the strength of the glue first. In general, when the strength is relatively strong, it is difficult to stick and pull apart, and can be seen when there is a phenomenon of glue drawing after pulling apart. At this time, the surface of the glue is not flowing glue, and it has been dried almost.
It is the most troublesome thing to have the raised edge of the site already used. The maintenance is rather troublesome. This requires cleaning up the filled quartz sand and rubber particles, then wiping the soil under the artificial lawn for bonding, after bonding, and then filling the quartz sand and rubber particles, which is simple to say but is really very troublesome to construct, especially quartz sand and rubber particles. It is very difficult to clean up and fill up with the original connection. So in the construction time must pay more attention to, take seriously, do a success.
News Center
中文版
English
ภาษาไทย
About Us
Your current location：