1. Glue: Require to use glue applicator on the surface of the brush, to thickness uniformity, can not be repeated glue, otherwise there will be bubbling phenomenon, or even fall off. The bottom cloth uses glue applicator, strictly control the thickness of glue, pay attention to the appropriate speed of glue coating, glue coating should be applied on the two bonded surface.
2. Adhesion: According to the actual influence of temperature, humidity, air pressure and other conditions at that time, reasonably control the airing time. In general, 10 to 30 minutes after gelatinization, the adhesive paste is eight or nine dry. Require the use of seam bonder, bonding requires one-time alignment firmly, must not be in the bonding later back to move the bonded object.
3. Pressure: After bonding, remove the surface debris, with a special rubber hammer from the bonding place to both sides of the hammer, so that the surface of the full contact dense, bonding more firmly.
4, curing: the curing time is usually three days, and the final strength is usually ten days. Therefore, it is necessary to pay close attention to its maintenance during solidification, to avoid excessive exposure, immersion and movement, in order to achieve the best bonding state. After bonding, before spraying quartz sand and rubber particles, it is necessary to use imported cleaners to clean the cuttings of turf on artificial lawn sites.
Attention should be paid during the construction: in the construction of artificial turf bonding, the adhesive should not be exposed to the field of time, because the volatilization of solvent will cause excessive viscosity and can not be constructed. If the temperature is too low, hot water can be used to heat up to 15 - 20 degrees Celsius, can be restored to the original state, and the performance remains unchanged.
News Center
中文版
English
ภาษาไทย
About Us
Your current location：